RIDGID R29302 Uživatelský manuál stáhnout pdf (Strana 4)

ure 9

1. Place the insert ring into the center hole of

the Lift’s top plate (Fig. 5).

2. Wi

th the insert wrench provided, insert

the

prongs of the wrench into the

corresponding holes in the insert ring and

turn the insert ring counter clockwise to

tighte

Turn the

insert wrench clockwise to loosen and

remove the ring. If the insert ring becomes too tight to

loosen with hand pressure, a tap clockwise on the

insert wrench with a block of wood will loosen it.

INSTALLING A JESSEM LIFT IN A CUSTOM

ROUTER TABLE APPLICATION

A JessEm router lift is similar to us

ng a router

mounting plate. Your table top must h

ve a port

machined into the top. JessEm offers so

phenolic router tables tops with pre-machined

orts for all JessEm router lifts. If you are

inst

lling this Lift in a custom table application

you will have to fabricate this opening yourself.

Jes

Em offers a separate template for this

operation. See your JessEm distributor for the

proper templa

e for your JessEm Mast-R-Lift II.

DJUSTING THE FIT IN THE TABLE PORT

Your Mast-R-Lift™ II comes with adjustable snugger

bars to allow for a tight fit in the table top

opening and eliminate any movement of the

plate. Use the 3/16” hex key provided to loosen

the cap screws on the snugger bars. Move the bars

out slightly and check for fit. Adjust again if

necessary. (Figure 9)

Figure 10

ure 8

LEVELIN

THE LIFT IN THE TABLE T

1. With the Mast

Lift™ II in the table top

opening, install (10) set screws into the

holes around the lift perimeter. Adjust

(Figure 8) the four corners first to align the

lift surface to the table surface so that

both ar

e flush. Adjust the remaining

set

screws on the sides to provide added

support.

TAB-LOC PHENOLIC INSERT RINGS

Your Mast-R-Lift™ II comes with one 2” insert ring with

a pre-drilled center hole. Additional ring sets are

available with different diameter pre-drilled holes

and/or no pre-drilled holes for creating your own

custom center hole diameters. See your JessEm

distributor for these and other accessories

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

RIDGID R29302 Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Sítě RIDGID R29302