Ridgid WL1200LS1 Uživatelský manuál stáhnout pdf (Strana 20)

20

Assembly (continued)

Spur and Cup Center Installation

1. From the loose parts package find the

following:

1 3/4-16 Hex Nut

1 Spur Center

1 Live Center

2. Screw nut onto head stock spindle until

finger tight.

3. To insert point into spur center, place

center between jaws of a vise. Do not

tighten vice. Insert point into center and

with a hammer and nail gently tap

around the base of the point until

secure.

NOTE: A piece of cloth may be wrapped

around the centers to protect them before

inserting into a vise.

Place the wood between the centers and

lock the tailstock.

4. Use a clean cloth to remove any oil or

other debris form the taper of each cen-

ter and the inside bore on both head-

stock spindle and tailstock ram.

5. Insert spur center into head stock spin-

dle and live center into tailstock ram.

NOTE: Do not drive or hammer centers

into spindle or ram as removal may be dif-

ficult.

6. To remove spur center from spindle,

place a wrench on the “flats” of the spin-

dle and turn hex nut counterclockwise

until center is ejected. Do not use index

pin to hold pulley.

The spur center may also be removed

with a 3/8" dia. wood dowel or brass

rod through the hole in the spindle of

headstock. Hold the center with one

hand tap the dowel or rod with a ham-

mer.

7. To remove live center insert a 3/8" dia.

wood dowel or brass rod through the

hole in the tailstock ram. Hold the cen-

ter with one hand and tap the dowel or

rod with a hammer.

Hex Nut 3/4-16

Live Center

Tailstock Ram

1/4" Dia.

Wood Dowe

l

Foo

t

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Komentáře k této Příručce

Žádné komentáře