RIDGID SS1650 1 Návod k obsluze stáhnout pdf (Strana 10)

ASSEMBLY

ASSEMBLING UPPER BRACE

See Figures 17-18

n Locate the following parts and hardware.

Carriage Bolts, M8 x 1.25-16 (16)

Hex Flanged Nuts, M8 x 1.25 (16)

Upper Braces (Stamped “A”, one with logo) (4)

Fig. 16

Fig. 17

Fig. 18

n Position the upper brace inside the leg/lower brace

assembly at the required setting.

n Place two carriage bolts through each hole as shown

and finger tighten each nut

MOUNTING TABLE BOARDS

See Figures 19-21

n Locate the following parts and hardware.

Pan Hd. Screws, M6 x 1.0-30 (4)

Washers, M6 (8)

Lock Washers, M6 (4)

Pan Hd. Screws, Ty “AB” M4 x 20 (4)

Hex Nuts, M6 (4)

Tables (Particle Board Layout marks not shown) (2)

Fig. 19

n Position the tables on the assembled leg stand. Make

sure the counter-bored holes are facing up and closer to

the outside.

n Place two pan head screws 1/4-20 x 1-1/4 through flat

washer through the table(s) and then leg stand. Secure

with flat washer, lockwasher and hex nut as shown.

Finger tighten only.

n Place a straightedge or flat board against the 8 in. edge

of the table boards to align the two table boards. For

the narrowest width maintain 4 in. between the table

boards. Maintain 6 in. for the middle width and 8 in. for

the widest width.

Fig. 20

STRAIGHTEDGE

UPPER BRACE

8 in.

6 in.

4 in.

1 2 ... 5 6 7 8 9 10 11 12 13

Žádné komentáře

RIDGID SS1650 1 Návod k obsluze Strana 10