RIDGID SS1650 1 Návod k obsluze stáhnout pdf (Strana 6)

TOOLS NEEDED

The following tools (not included) are needed for properly assembling your Universal Benchtop Power Tool Leg Stand.

WRENCHES (3)

(10mm, 13mm, 9/16 in.)

#2 PHILLIPS SCREWDRIVER

HAND DRILL

DRILL BIT

(5/16 in.)

PHILLIPS BIT (#2)

ASSEMBLY

WIDTH ADJUSTMENT

See Figure 1

As assembled later, there are three widths to choose from

for each of the sides of the legset.

WIDTH ADJUSTMENT (3 TOTAL)HEIGHT ADJUSTMENT

HEIGHT ADJUSTMENT

See Figure 2

As assembled later, there are five heights to choose from

for each leg of the legset. Three are shown below.

The Universal Benchtop Power Tool Leg Stand may be

assembled in many different height and width configurations.

Many combinations of height and width are possible.

HEIGHT ADJUSTMENT (5 TOTAL)

Fig. 1

Fig. 2

PLANNING FOR MOUNTING RIDGID POWER

TOOLS

See Figure 3

Below is the layout template with the recommended

configurations for the RIDGID products currently available.

The template will be positioned on both boards and marked

either for:

n Drilling holes and mounting tool(s) with screw, washers,

and nuts.

n Using self tapping screws (such as wood screws) to

mount tool(s).

Fig. 3

TALLEST

MIDDLE

SHORTEST

1 2 3 4 5 6 7 8 9 10 11 12 13

Žádné komentáře

RIDGID SS1650 1 Návod k obsluze Strana 6