
11
ASSEMBLY
n Using a drill or phillips screwdriver, drive the four
pan head screws Ty “AB” M4 x 20 from below as
shown(No pilot hole is needed).
FINAL ASSEMBLY
n Place the tool in the location it will be used. Securely
tighten all nuts, bolts, and screws.
n Adjust and tighten leveling feet.
MOUNTING BENCHTOP TOOL
n The layout template is for RIDGID benchtop power
tools only.
n The “Planning For Mounting Ridgid Power Tools”
section of this manual shows the recommended
mounting for RIDGID tools.
n The tools can be mounted with bolt & nut hardware or
wood screw hardware.
n The layout template will line up the larger bolt & nut
holes and the wood screw holes on your RIDGID
tool if you assembled the stand per our earlier
recommendation.
Fig. 21
Fastener Hardware
Power Tool Bolts & Nuts Qty. Drywall Screws Qty.
SS1650 16 in. Scroll Saw 1/4-20 x 2 in. Bolt
1/4-20 Nu
t
1/4 Lockwasher
1/4 Flat Washer
3
3
3
3
#10 x 1-1/2 in.
Screw
Washer - ID 1/4 in
.
3
3
MS1050 10 in.
MS1250 12 in.
Compoun
d
Mite
r Saw
1/4-20
x 2-1/2 Bolt
1/4-20 Nu
t
1/4 Lockwasher
1/4 Flat Washer
4
4
4
4
#8 x 1-
3/4" Screw
#8 x 1-
3/4 in. Screw
4
4
t
Sande
r
TS2400 Jobsite Table Saw
TP1300 13 in
ickness
Plane
r
1/4-20
x 3-1/2 in.
Bolt
1/4-20 Nu
t
1/4 Lockwasher
1/4 Flat Washer
4
4
4
4
#8 x 3 in. Scre
w
#8 x 3-1/4 in.
Screw
#8 x 2-
3/4 in. Screw
4
4
4
Compound
Mite
r Saw
n Place the layout template on the particle board
table(s) and mark the correct hole locations.
n If you use “bolt & nut” fasteners, use a 5/16 in. drill bit
(not supplied) and drill the appropriate holes labeled
with your model number shown by a " " symbol.
n Place the appropriate bolt through the benchtop
power tool and table(s). Place a flat washer, lock
washer and nut on the bolt. Securely tighten nut.
n If you use wood screws, line the tool up using the
drywall hole pattern with your model number shown
with a " " . Place the wood screws through the
smaller holes in the tool base and then drive them
into the wood.
Hardware for mounting the tool to the leg stand is not
supplied.
However, the following hardware is recommended
FLAT WASHER
PAN HD. SCREW
PAN HD.
SCREW
FLAT WASHER
LOCK WASHER
HEX NUT
PAN HD.
SCREW
Komentáře k této Příručce